NOW AVAILABLE!

Requires SwitchGlo Pro Version 6 Firmware for LED to function

Kit includes: 3-way circuit board, Pushbutton (installed), surface mount LED (installed), thru-hole LED (alternative), 18" of 4 conductor ribbon cable.

This KiT allows do-it-yourselfer's to build your own custom switch and LED accessory. This 3-way module is designed to be cut into 2 or 3 pieces:

1. Accessory Port Plug-in (APP)
2. Pushbutton
3. LED

The 3-way circuit works right out of the package by inserting the APP into the SwitchGlo Pro / PushGlo Accessory Port in either direction. Verify a working circuit before you cut the dashed lines to separate the circuits. Use scissors to cut the APP from the Pushbutton/LED circuit. You can stop there and cut your desired wire length. Strip and solder the wires from the APP pin1 & 2’s, to their respective to pin 1 & 2’s on the Pushbutton/LED circuit. You can further customize by cutting the Pushbutton/LED circuits apart to mount the LED in a totally different location then the Pushbutton. The ribbon cable will spread apart easily to accommodate separating the Pushbutton and LED circuits. Trim the edges as desired.

For extreme customization, we have provided a thru-hole red LED. It can soldered right above the existing LED, short leg next to the white dot. You can remove the existing LED to make the thru-hole LED brighter. For extreme tinkerers, we even included holes for a thru hole resistor in case a different LED intensity is desired. Remove the existing 120ohm surface mount resistor if you add your own.

Compatible Device: SwitchGlo Pro (V6), PushGlo